Stainless Steel Syringe Filter Holders

Stainless Steel Syringe Filter Holders

Reusable Syringe Filter Holders

Description

MS re-usable Stainless Steel Holder for particle removal and sterilisation of up to 100ml volumes of solvents and aggressive liquids. Filter supports in the top and bottom parts allow filtration in either direction. No sealing ring or gasket is required, as a PTFE coated surface on the top part ensures leakproof sealing using the tightening tool in which the holder is supplied. The holder can be sterilised by auto-claving or in an oven at 180°C.

Specifications

· Compatibility Chemical resistance as for stainless steel

· Connectors Luer lock inlet and Luer slip outlet

· Dead volume Less than 0.1ml after overcoming the bubble point of the filter used

· Filter Requires 25mm diameter membrane filter

· 25 mm diameter filtration area 3 cm2

· Flow rates Typical values for water at 1 bar (100 kPa), 45 ml/min with 0.2μm, 80ml/min

with 0.45 μm pore size filters

· Materials Stainless steel top and bottom part. PTFE coating in top part.

· Luran368R tightening tool

· Pressure limit Max. operating pressure, 7 bar (700 kPa)

· Sterilisation By autoclaving (121°C or 134°C) or dry heat (180°C)